OSHA & ISNetworld® RAVS® Safety Manuals for Roofing Contractors
Designed for low-slope commercial TPO/EPDM/built-up roofing and steep-slope contractors. Addresses OSHA’s #1 most-cited construction standard (1926.501 Fall Protection), Warning Line & Safety Monitor Systems, Written Fall Rescue Plans, Hot Asphalt/Torch Fire Watch, Ladders, and Outdoor Heat Illness.
Primary OSHA & Industry Standards Covered
Every Commercial & Residential Roofing Contractors safety manual is pre-customized with your Company Name and Safety Director and addresses these critical audit standards:
- 29 CFR 1926.501(b)(10) & (b)(11) — Low-Slope & Steep-Slope Roofing Fall Protection
- 29 CFR 1926.502(f) & (h) — Warning Line Systems (6 ft / 15 ft Rules) & Safety Monitoring
- ANSI Z359 & 29 CFR 1926.502(d)(20) — Prompt Post-Fall Rescue Plan & Suspension Trauma Prevention
- 29 CFR 1926.1053 (Subpart X) — Extension Ladder 3-Foot Extension, 4:1 Angle & Tie-Off
- 29 CFR 1926.150–152 — Torch-Applied Roofing, Hot Kettles & Flammable Adhesives Fire Prevention
Included Pre-Task Job Hazard Analysis (JHA) Templates
Available in our Site-Specific SSSP/HASP Pack ($99) and Pro Contractor System ($249):
- Roof Access Setup, Extension Ladder Tie-Off & Perimeter Warning Line Installation
- Existing Roof Tear-Off, Roof Deck Inspection & Skylight/Floor Hole Coverings
- Crane / Telehandler Material Loading onto Roof Deck & Weight Distribution
- TPO / PVC Membrane Heat Welding & Solvent Adhesive Application (HazCom & Fire Watch)
- Steep-Slope Anchor Point Installation, Personal Fall Arrest & Rescue Readiness
Core Written Safety Program Chapters for Commercial & Residential Roofing Contractors
Your Complete Manual ($149) includes all 24 written safety programs, with special emphasis on the core Roofing chapters below (or buy any single chapter for $49):
| Code | Written Safety Program Title | Construction CFR | Key Field Requirement | Single Chapter |
|---|---|---|---|---|
| SEC-01 | Injury & Illness Prevention Program (IIPP) / Corporate Safety Policy | 29 CFR 1926.20–21 / Title 8 CCR §3203 & §1509 / WAC 296-155-110 | Designated Safety Director & Site Competent Person authority to stop unsafe work immediately | Buy ($49) |
| SEC-02 | Fall Protection, Guardrails & Post-Fall Rescue Plan | 29 CFR 1926.500–503 (Subpart M) | Mandatory fall protection at ≥6 feet on construction sites (≥4 feet in general industry facilities) | Buy ($49) |
| SEC-10 | Portable Ladders, Stairways & Safe Access Program | 29 CFR 1926.1050–1060 (Subpart X) | Provide a stairway or ladder at all points of access where there is a break in elevation of 19 inches or more | Buy ($49) |
| SEC-11 | Supported & Mobile Scaffolding Safety Program | 29 CFR 1926.450–454 (Subpart L) | Erect, move, dismantle, or alter scaffolds only under the direct supervision of a trained Scaffold Competent Person | Buy ($49) |
| SEC-09 | Fire Prevention, Welding, Cutting & Hot Work Permit Program | 29 CFR 1926.150–155 (Subpart F) & 1926.350–354 (Subpart J) | Issue a signed Hot Work Permit before any welding, torch cutting, brazing, soldering, torch roofing, or spark-producing grinding outside a designated shop area | Buy ($49) |
| SEC-15 | Heat Illness Prevention, Acclimatization & Hydration Plan | OSHA NEP on Outdoor/Indoor Heat / Title 8 CCR §3395–3396 / WAC 296-62-095 | Provide fresh, pure, suitably cool potable drinking water as close as practicable to work areas at no cost (minimum 1 quart / 32 oz per employee per hour for the entire shift) | Buy ($49) |
| SEC-13 | Cranes, Derricks, Rigging & Qualified Signal Person Program | 29 CFR 1926.1400–1442 (Subpart CC) & 1926.251 (Rigging) | All rigging must be performed by a Qualified Rigger and hand/radio crane signals given exclusively by a Qualified Signal Person (though anyone may give an Emergency Stop signal) | Buy ($49) |
| SEC-07 | Respirable Crystalline Silica Written Exposure Control Plan | 29 CFR 1926.1153 (Table 1 Specified Exposure Control Methods) | Full implementation of 29 CFR 1926.1153(c)(1) Table 1 engineering controls (continuous water feed to blade/bit or commercially available shroud + ≥99% HEPA vacuum with filter-cleaning mechanism) | Buy ($49) |
| SEC-14 | Personal Protective Equipment (PPE) & Hazard Assessment Program | 29 CFR 1926.95–106 (Subpart E) | Perform and certify in writing a Workplace PPE Hazard Assessment for each trade task and provide required PPE at no cost to employees | Buy ($49) |
| SEC-08 | Hazard Communication (HazCom) & GHS Safety Data Sheets Program | 29 CFR 1926.59 | Maintain an up-to-date Master Chemical Inventory List and 16-section Safety Data Sheets (SDS) immediately accessible to all workers on every shift (binder and/or mobile digital access with zero barriers) | Buy ($49) |
| SEC-16 | Hand & Portable Power Tools, Guards & Pneumatic/Powder-Actuated Tools | 29 CFR 1926.300–307 (Subpart I) | Keep all manufacturer guards in place and operable on circular saws, angle grinders, chop saws, and portable tools; tampering with or wedging guards open is a zero-tolerance violation | Buy ($49) |
| SEC-12 | Mobile Elevating Work Platforms (MEWPs) — Aerial & Scissor Lifts | 29 CFR 1926.453 (Aerial Lifts) & 1926.452(w) (Scissor Lifts) | 100% tie-off required at all times inside boom lifts using a short restraint/SRL lanyard attached to the manufacturer’s designated boom basket anchor (never tie off to adjacent structures or conduit) | Buy ($49) |
| SEC-04 | Electrical Safety, Arc Flash & NFPA 70E Compliance Program | 29 CFR 1926.400–449 (Subpart K) | De-energize all circuits ≥50V before work unless de-energizing creates a greater hazard or is infeasible (requires signed Energized Electrical Work Permit) | Buy ($49) |
| SEC-21 | Emergency Action Plan (EAP), Medical Evacuation & Severe Weather | 29 CFR 1926.35 & 1926.50 | Post the site-specific Emergency Action Plan at the jobsite board/gangbox before work begins, including the exact physical street address/GPS coordinates, nearest Level I/II Hospital map, and Emergency Coordinator phone numbers | Buy ($49) |
| SEC-22 | Incident Investigation, Root Cause Analysis & OSHA 300 Recordkeeping | 29 CFR Part 1904 (1904.1–1904.46) | Report all work-related injuries, illnesses, property damage, and near-misses to the immediate Supervisor and Safety Director immediately (written Incident Report completed within 24 hours) | Buy ($49) |
| SEC-23 | Subcontractor Safety Prequalification & Multi-Employer Coordination | 29 CFR 1926.16 & OSHA Directive CPL 02-00-124 | Prequalify all tiered subcontractors prior to contract award by reviewing 3 years of EMR, TRIR, DART rates, OSHA citation history, written safety programs, and Competent Person credentials | Buy ($49) |
Explore Other Contractor Trade Manuals:
Electrical & High-Voltage ContractorsHVAC, Mechanical & Sheet Metal ContractorsPlumbing, Pipefitting & Utility ContractorsCommercial & Residential Roofing ContractorsExcavation, Trenching, Grading & Civil ContractorsConcrete, Masonry & Structural ContractorsCommercial General Contractors & Construction ManagersIndustrial Maintenance, Millwright & Welding Contractors