OSHA & ISNetworld® RAVS® Safety Manuals for Electrical Contractors
Engineered for commercial, industrial, and utility electrical subcontractors. Covers NFPA 70E Arc Flash & Approach Boundaries, Energized Electrical Work Permits, Lockout/Tagout (LOTO), Assured Equipment Grounding Conductor Program (AEGCP) & GFCI protection, Aerial Lifts, and Fall Protection.
Primary OSHA & Industry Standards Covered
Every Electrical & High-Voltage Contractors safety manual is pre-customized with your Company Name and Safety Director and addresses these critical audit standards:
- 29 CFR 1926.400–449 (Subpart K — Electrical Installation & Work Practices)
- NFPA 70E (2024 Edition) — Arc Flash Hazard Analysis, PPE Categories 1–4 & Approach Boundaries
- 29 CFR 1910.147 & 1926.417 — Control of Hazardous Energy (Lockout / Tagout)
- 29 CFR 1926.404(b)(1) — GFCI Protection & Assured Equipment Grounding Conductor Program
- 29 CFR 1926.501–503 — Fall Protection, Scissor Lifts & Articulating Boom Lifts (1926.453)
Included Pre-Task Job Hazard Analysis (JHA) Templates
Available in our Site-Specific SSSP/HASP Pack ($99) and Pro Contractor System ($249):
- Panelboard & Switchgear De-Energization / LOTO Verification (Zero-Energy Check)
- Overhead Conduit & Cable Tray Installation from Scissor / Boom Lift
- Underground Duct Bank Trenching & Conduit Placement
- Transformer & Generator Rigging, Setting, and Termination
- Troubleshooting Energized Control Circuits (<480V) Under NFPA 70E Permit
Core Written Safety Program Chapters for Electrical & High-Voltage Contractors
Your Complete Manual ($149) includes all 24 written safety programs, with special emphasis on the core Electrical chapters below (or buy any single chapter for $49):
| Code | Written Safety Program Title | Construction CFR | Key Field Requirement | Single Chapter |
|---|---|---|---|---|
| SEC-01 | Injury & Illness Prevention Program (IIPP) / Corporate Safety Policy | 29 CFR 1926.20–21 / Title 8 CCR §3203 & §1509 / WAC 296-155-110 | Designated Safety Director & Site Competent Person authority to stop unsafe work immediately | Buy ($49) |
| SEC-04 | Electrical Safety, Arc Flash & NFPA 70E Compliance Program | 29 CFR 1926.400–449 (Subpart K) | De-energize all circuits ≥50V before work unless de-energizing creates a greater hazard or is infeasible (requires signed Energized Electrical Work Permit) | Buy ($49) |
| SEC-03 | Control of Hazardous Energy — Lockout / Tagout (LOTO) | 29 CFR 1926.417 & 1926.702(j) | Strict "One Person, One Lock, One Key" rule using standardized, durable, uniquely keyed LOTO padlocks and tags | Buy ($49) |
| SEC-02 | Fall Protection, Guardrails & Post-Fall Rescue Plan | 29 CFR 1926.500–503 (Subpart M) | Mandatory fall protection at ≥6 feet on construction sites (≥4 feet in general industry facilities) | Buy ($49) |
| SEC-12 | Mobile Elevating Work Platforms (MEWPs) — Aerial & Scissor Lifts | 29 CFR 1926.453 (Aerial Lifts) & 1926.452(w) (Scissor Lifts) | 100% tie-off required at all times inside boom lifts using a short restraint/SRL lanyard attached to the manufacturer’s designated boom basket anchor (never tie off to adjacent structures or conduit) | Buy ($49) |
| SEC-10 | Portable Ladders, Stairways & Safe Access Program | 29 CFR 1926.1050–1060 (Subpart X) | Provide a stairway or ladder at all points of access where there is a break in elevation of 19 inches or more | Buy ($49) |
| SEC-14 | Personal Protective Equipment (PPE) & Hazard Assessment Program | 29 CFR 1926.95–106 (Subpart E) | Perform and certify in writing a Workplace PPE Hazard Assessment for each trade task and provide required PPE at no cost to employees | Buy ($49) |
| SEC-08 | Hazard Communication (HazCom) & GHS Safety Data Sheets Program | 29 CFR 1926.59 | Maintain an up-to-date Master Chemical Inventory List and 16-section Safety Data Sheets (SDS) immediately accessible to all workers on every shift (binder and/or mobile digital access with zero barriers) | Buy ($49) |
| SEC-06 | Permit-Required Confined Space Entry (Construction & General Industry) | 29 CFR 1926.1201–1213 (Subpart AA) | Pre-entry and continuous 4-gas atmospheric monitoring in strict order: 1. Oxygen (19.5%–23.5%), 2. Flammable Gases (<10% LEL), 3. Carbon Monoxide (<25–35 ppm), 4. Hydrogen Sulfide (<10 ppm) | Buy ($49) |
| SEC-05 | Trenching, Excavation & Underground Utility Protection | 29 CFR 1926.650–652 (Subpart P) | Call 811 at least 48–72 hours prior to digging; hand dig or vacuum pothole within 24 inches of marked underground utilities | Buy ($49) |
| SEC-16 | Hand & Portable Power Tools, Guards & Pneumatic/Powder-Actuated Tools | 29 CFR 1926.300–307 (Subpart I) | Keep all manufacturer guards in place and operable on circular saws, angle grinders, chop saws, and portable tools; tampering with or wedging guards open is a zero-tolerance violation | Buy ($49) |
| SEC-09 | Fire Prevention, Welding, Cutting & Hot Work Permit Program | 29 CFR 1926.150–155 (Subpart F) & 1926.350–354 (Subpart J) | Issue a signed Hot Work Permit before any welding, torch cutting, brazing, soldering, torch roofing, or spark-producing grinding outside a designated shop area | Buy ($49) |
| SEC-07 | Respirable Crystalline Silica Written Exposure Control Plan | 29 CFR 1926.1153 (Table 1 Specified Exposure Control Methods) | Full implementation of 29 CFR 1926.1153(c)(1) Table 1 engineering controls (continuous water feed to blade/bit or commercially available shroud + ≥99% HEPA vacuum with filter-cleaning mechanism) | Buy ($49) |
| SEC-15 | Heat Illness Prevention, Acclimatization & Hydration Plan | OSHA NEP on Outdoor/Indoor Heat / Title 8 CCR §3395–3396 / WAC 296-62-095 | Provide fresh, pure, suitably cool potable drinking water as close as practicable to work areas at no cost (minimum 1 quart / 32 oz per employee per hour for the entire shift) | Buy ($49) |
| SEC-21 | Emergency Action Plan (EAP), Medical Evacuation & Severe Weather | 29 CFR 1926.35 & 1926.50 | Post the site-specific Emergency Action Plan at the jobsite board/gangbox before work begins, including the exact physical street address/GPS coordinates, nearest Level I/II Hospital map, and Emergency Coordinator phone numbers | Buy ($49) |
| SEC-22 | Incident Investigation, Root Cause Analysis & OSHA 300 Recordkeeping | 29 CFR Part 1904 (1904.1–1904.46) | Report all work-related injuries, illnesses, property damage, and near-misses to the immediate Supervisor and Safety Director immediately (written Incident Report completed within 24 hours) | Buy ($49) |
Explore Other Contractor Trade Manuals:
Electrical & High-Voltage ContractorsHVAC, Mechanical & Sheet Metal ContractorsPlumbing, Pipefitting & Utility ContractorsCommercial & Residential Roofing ContractorsExcavation, Trenching, Grading & Civil ContractorsConcrete, Masonry & Structural ContractorsCommercial General Contractors & Construction ManagersIndustrial Maintenance, Millwright & Welding Contractors